mpas_analysis.ocean.MeridionalHeatTransport

class mpas_analysis.ocean.MeridionalHeatTransport(config, mpasClimatologyTask, controlConfig=None)

Plot meridional heat transport from the analysis member output.

Variables

• ~MeridionalHeatTransport.mpasClimatologyTask (MpasClimatologyTask) – The task that produced the climatology to be remapped and plotted

• ~MeridionalHeatTransport.controlConfig (MpasAnalysisConfigParser) – Configuration options for a control run (if any)

__init__(config, mpasClimatologyTask, controlConfig=None)

Construct the analysis task.

Parameters

• config (MpasAnalysisConfigParser) – Configuration options

• mpasClimatologyTask (MpasClimatologyTask) – The task that produced the climatology to be remapped and plotted

• controlConfig (MpasAnalysisConfigParser, optional) – Configuration options for a control run (if any)

Methods

__init__(config, mpasClimatologyTask[, ...])	Construct the analysis task.
add_subtask(subtask)	Add a subtask to this tasks.
check_analysis_enabled(analysisOptionName[, ...])	Check to make sure a given analysis is turned on, issuing a warning or raising an exception if not.
check_generate()	Determines if this analysis should be generated, based on the generate config option and taskName, componentName and tags.
close()	Close the Process object.
is_alive()	Return whether process is alive
join([timeout])	Wait until child process terminates
kill()	Terminate process; sends SIGKILL signal or uses TerminateProcess()
run([writeLogFile])	Sets up logging and then runs the analysis task.
run_after(task)	Only run this task after the given task has completed.
run_task()	Process MHT analysis member data if available. Plots MHT as: 1D function of latitude 2D function of latitude and depth.
set_start_end_date(section)	Set the start and end dates in the config correspond to the start and end years in a given category of analysis
setup_and_check()	Perform steps to set up the analysis and check for errors in the setup.
start()	Start child process
terminate()	Terminate process; sends SIGTERM signal or uses TerminateProcess()

Attributes

BLOCKED
FAIL
READY
RUNNING
SUCCESS
UNSET
authkey
daemon	Return whether process is a daemon
exitcode	Return exit code of process or None if it has yet to stop
ident	Return identifier (PID) of process or None if it has yet to start
name
pid	Return identifier (PID) of process or None if it has yet to start
sentinel	Return a file descriptor (Unix) or handle (Windows) suitable for waiting for process termination.