mpas_analysis.ocean.ClimatologyMapFluxes¶
- class mpas_analysis.ocean.ClimatologyMapFluxes(config, mpasClimatologyTask, controlConfig=None, fluxType='mass')[source]¶
An analysis task for plotting sea surface fluxes. Observational comparison is not supported because no observational datasets are currently available.
- __init__(config, mpasClimatologyTask, controlConfig=None, fluxType='mass')[source]¶
Construct the analysis task.
- Parameters:
config (mpas_tools.config.MpasConfigParser) – Configuration options
mpasClimatologyTask (
MpasClimatologyTask
) – The task that produced the climatology to be remapped and plottedcontrolconfig (mpas_tools.config.MpasConfigParser, optional) – Configuration options for a control run (if any)
fluxType (str, optional) – The type of surface fluxes, which corresponds to a different config section. One of ‘mass’ or ‘heat’.
Methods
__init__
(config, mpasClimatologyTask[, ...])Construct the analysis task.
add_subtask
(subtask)Add a subtask to this tasks.
check_analysis_enabled
(analysisOptionName[, ...])Check to make sure a given analysis is turned on, issuing a warning or raising an exception if not.
check_generate
()Determines if this analysis should be generated, based on the
generate
config option andtaskName
,componentName
andtags
.close
()Close the Process object.
is_alive
()Return whether process is alive
join
([timeout])Wait until child process terminates
kill
()Terminate process; sends SIGKILL signal or uses TerminateProcess()
run
([writeLogFile])Sets up logging and then runs the analysis task.
run_after
(task)Only run this task after the given task has completed.
run_task
()Run the analysis.
set_start_end_date
(section)Set the start and end dates in the
config
correspond to the start and end years in a given category of analysissetup_and_check
()Perform steps to set up the analysis (e.g. reading namelists and streams files).
start
()Start child process
terminate
()Terminate process; sends SIGTERM signal or uses TerminateProcess()
Attributes
BLOCKED
FAIL
READY
RUNNING
SUCCESS
UNSET
authkey
daemon
Return whether process is a daemon
exitcode
Return exit code of process or None if it has yet to stop
ident
Return identifier (PID) of process or None if it has yet to start
name
pid
Return identifier (PID) of process or None if it has yet to start
sentinel
Return a file descriptor (Unix) or handle (Windows) suitable for waiting for process termination.